
7.Press a 2” x 3” Inner Cap (58) into the top of the Squat Upright (4). Slide the Squat Upright onto the two indicated 5/16” x 2 1/2” Carriage Bolts (110) in the Long Base (120). Finger tighten a 5/16” Nylon Locknut (86) onto each Carriage Bolt. Do not tight- en the Nylon Locknuts yet.
Press a 2” x 3” Inner Cap (58) into the top of the VKR Upright (5). Slide the VKR Upright onto the two indicated 5/16” x 2 1/2” Carriage Bolts (110) in the Long Base (120). Finger tighten a 5/16” Nylon Locknut (86) onto each Carriage Bolt. Do not tight- en the Nylon Locknuts yet.
8.Locate the four slotted holes in the brackets on the Squat Slider (38). Attach a Roller (39) and two 5/16” Washers (90) between each pair of slotted holes with a 5/16” x 3 1/2” Bolt (94), two 5/16” Lock Washers (115), and a 5/16” Nylon Locknut (86) as shown. Do not tighten the Nylon Locknuts yet.
Next, attach a Roller (39) and two 5/16” Washers (90) between each pair of small round holes with a 5/16” x 3 1/2” Bolt (94), two 5/16” Washers (90), and a 5/16” Nylon Locknut (86) as shown. Do not tighten the Nylon Locknuts yet.
See the inset drawing. Slide the Squat Slider (38) down onto the Squat Upright (4). Push the two indi- cated Rollers (39) against the Squat Upright.
Tighten all of the 5/16” Nylon Locknuts (86) used in this step.
7 |
| 58 |
|
|
|
|
|
| |
|
|
| 58 |
|
|
| 5 |
|
|
|
|
| 4 |
|
| 86 |
|
|
|
110 |
|
| 120 | 86 |
|
|
| ||
|
|
| 110 |
|
8 | 39 | 90 |
|
|
|
|
| ||
| 115 | 86 |
| |
| 90 |
| ||
|
| 90 |
| |
115 |
| 39 |
| |
|
|
|
| |
|
|
| 90 |
|
94 | 115 |
| 86 38 |
|
| 86 |
| ||
|
|
|
| |
115 |
| 90 |
| |
|
|
|
| |
|
| 90 | 38 | |
|
|
| ||
94 | 90 |
| 39 |
|
| 39 | 39 |
| |
|
| 90 |
|
|
|
|
|
| 4 |
8