![](/images/new-backgrounds/1255010/25501023x1.webp)
13. Attach a Seat Arm (26) to the Sliding Seat Frame | 13 |
| |
(8) with two M6 x 35mm Bolts (83) and two M6 |
| ||
|
| ||
Nylon Locknuts (102). |
|
| |
Repeat with the other Seat Arm (26). |
|
| |
|
| 26 | |
| 102 |
| |
| 8 |
| |
| 83 |
| |
| 26 |
| |
14. Press a 50mm Thick Angled Cap (109) into the | 14 |
| |
top of the Rear Press Arm (13). Press a 50mm |
| ||
|
| ||
Angled Cap (108) into the top of the Front Press | 109 |
| |
Arm (14). |
| ||
|
| ||
| 108 |
| |
Lubricate an M10 x 77mm Bolt (106) with grease. | 13 |
| |
|
| ||
Attach the Rear Press Arm (13), which has a hole | 14 |
| |
in the lower area, to the Leg Press Base (3) with |
|
| |
the Bolt and an M10 Nylon Locknut (101). Do not |
|
| |
overtighten the Locknut; the Press Arm must | Hole |
| |
be able to pivot easily. |
| ||
|
| ||
Attach the Front Press Arm (14) to the Leg |
| 106 | |
|
| ||
Press Base (3) in the same manner. |
|
| |
| 3 |
| |
| 101 |
| |
15. Lubricate wo M10 x 80mm Bolts (110) with | 15 |
| |
grease. Attach the two Leg Press Brackets (16) to |
| ||
|
| ||
the Press Arms (13, 14) with the Bolts and two | Lubricate | ||
M10 Nylon Locknuts (101). Do not tighten the | 13 | 110 | |
Locknuts yet. Make sure the warining decal is | |||
| |||
|
| ||
in the location shown. |
| 16 | |
|
| ||
|
| 14 | |
| 101 |
| |
| 16 |
| |
| Warning |
| |
| Decal |
|
12