Weider WESY49310 user manual 102

CABLE ASSEMBLY

24. See the inset drawing. Attach a 3 1/2” Pulley	24
(15) and a Cable Trap (66) to the upper hole in
a Long “U”-Bracket (57) with a 3/8” x 2” Bolt		58
(12) and a 3/8” Nylon Locknut (21). Be sure
that the Cable Trap is inside the Long “U”-
Bracket. Note: This may come pre-assem-	66	15
bled.
Route the High Cable (58) through the Long	21				15
“U”-Bracket (57) and the 3 1/2” Pulley (15)	57	12			58
shown in the inset drawing. Be sure that the
Cable is in the groove of the Pulley and that
the Cable and Pulley move smoothly.		57
25. Wrap the High Cable (58) around a 3 1/2”	25
Pulley (15). Attach the Pulley to the bracket on
		Bracket			12
the Top Frame (55) with a 3/8” x 2” Bolt (12)			58
	55
and a 3/8” Nylon Locknut (21). Be sure that
the Cable is in the groove of the Pulley and					15
that the Cable and Pulley move smoothly.
	21
26. Note: This assembly step shows how to	26
complete the assembly of several pre-
attached parts.
The 5/8” x 9/16” Spacer (7) has been pre-
attached on the outside of the 3 1/2” Low
Pulley (102) for shipping purposes. Remove
the 3/8” Nylon Locknut (21), the Spacer, and
the Pulley from the 3/8” x 3 3/4” Bolt (88). Do
not remove the Bolt. The Bolt has been
shown removed for part identification.
Reattach the 3 1/2” Low Pulley (102), with the
5/8” x 9/16” Spacer (7) between the Pulley and
the Press Frame (17). Do not tighten the 3/8”
Nylon Locknut (21) yet. Be sure that the
3/8” x 3 3/4” Bolt (88), the 3/8” Flat Washer				9	88
(9), the 5/8” x 9/16” Spacer, the 3 1/2” Low
Pulley, and the 3/8” Nylon Locknut are ori-
ented as shown.					7
			17		102
					21

13