Weider WESY49310 Locate the Low Cable 23. Route the Low, Pulley and the crossbar on the Press

CABLE ASSEMBLY

27. Locate the Low Cable (23). Route the Low	27
Cable under the 3 1/2” Low Pulley (102). Be
sure that the end of the Cable with the ball				21
is on the indicated side of the Press Frame
(17) and that the Cable is between the					102
Pulley and the crossbar on the Press					23
Frame. Tighten the 3/8” Nylon Locknut (21)
					Ball
and the 3/8” x 3 3/4” Bolt (not shown).
					17
		Crossbar
28. Wrap the Low Cable (23) around a 3 1/2”	28			23	15
Pulley (15). Attach the Pulley and a Cable
Trap (66) to the lower hole in the Front		42		21
Upright (42) with a 3/8” x 3 3/4” Bolt (88), a
			66
3/8” Washer (9), and a 3/8” Nylon Locknut		15			66
(21). See the inset drawing. Be sure that			21	42
the Cable Trap is turned to hold the Cable
in place and that the Cable and Pulley				Inset shows view
move smoothly.			23	from other side
	9
	88
29. Route the Low Cable (23) around the 3 1/2”	29
Pulley (15) attached to the upper hole in the
Press Frame (17). Be sure that the Cable
Trap (66) is turned to hold the Cable in				23
place and that the Cable is routed around				15
the Pulley as shown. Tighten the 3/8” Nylon				21
Locknut (21) and the 3/8” x 3 1/2” Bolt (not				66
shown).
				17
30. Wrap the Low Cable (23) around a 3 1/2”	30			23	15
Pulley (15). Attach the Pulley and a Cable			23
	42
Trap (66) to the upper hole in the Front			15	21
Upright (42) with a 3/8” x 3 3/4” Bolt (88), a
3/8” Washer (9), and a 3/8” Nylon Locknut			21		66
(21). See the inset drawing. Be sure that			66	42
the Cable Trap is turned to hold the Cable
in place and that the Cable and Pulley				Inset shows view
move smoothly.	88	9		from other side

14