Weider WESY49310 user manual Frame Assembly ARM Assembly

FRAME ASSEMBLY

ARM ASSEMBLY

9.	Attach the upper ends of the Short Weight	9	61		61
	Guides (73) to the Top Frame (55) with a 5/16”			3
	x 6” Bolt (60), two 1/2” x 3/4” Spacers (61), and					3
	a 5/16” Nylon Locknut (3).	60				55
	Attach the upper ends of the Long Weight
	Guides (62) to the Top Frame (55) in the same
	manner.	73		60
				62
10.	Locate and open the parts bag labeled	10			95	27
	“ARM ASSEMBLY.”
	Be sure there is a Bushing (98) in each side of					Welded
						Tube
	the Stabilizer (5). Press a 2” Square Inner Cap
	(27) into each end of the Leg Press Arm (96).					97
				96
	Lubricate a 3/8” x 3 1/4” Bolt (67). Attach the				21
	Leg Press Arm (96) to the Stabilizer (5) with the
	Bolt and a 3/8” Nylon Locknut (21). Do not over-					67—Lubricate
	tighten the Nylon Locknut. The Leg Press
	Arm must be able to pivot freely.			5	27
	Align the welded tubes on the Leg Press Plate				98
	(95) with one set of holes in the Leg Press Arm
	(96). Attach the Leg Press Plate to the Leg	11			17
	Press Arm with the Press Pin (97).					Pulleys
						must be on
11.	Press a 1” x 7/8” Plastic Bushing (90) onto					this side
	each welded spacer on the Press Frame (17).					59—Lubricate
	Slide the Press Frame into place onto the Base
	(4). Note: This will be a tight fit. The Plastic
	Bushings should fit on each end of the indi-
	cated tube in the Base. Make sure that the
	pulleys are on the side shown.			21	Welded Spacers
	Lubricate the 3/8” x 8” Bolt (59). Attach the	4
	Press Frame (17) to the Base (4) with the Bolt	Tube			90
	and a 3/8” Nylon Locknut (21).

8