Weider WESY49310 Tighten all Nylon Locknuts used in steps, Weights 25 until is complete

FRAME ASSEMBLY

4. Press a 2” Square Inner Cap (27) into the end	4	11		113
of the Top Frame (55). Press a 1 3/4” Square
		55		44
Inner Cap (44) into each end of the crossbar		8
on the Top Frame. Press two 1” Inner Caps	27
(113) into the top of the crossbar.		3
Attach the Top Frame (55) to the Assist
Upright (74) and the Leg Press Upright (56)			44	Crossbar
with two 5/16” x 2 3/4” Bolts (11) and two
5/16” Nylon Locknuts (3).
Attach the Top Frame (55) to the Front	11		3
Upright (42) with two 5/16” x 2 3/4” Bolts (11),
two 5/16” Flat Washers (8), and two 5/16”
Nylon Locknuts (3).
		56		42
		74
5. Slide the Rear Seat Frame (100) onto the
indicated 5/16” x 2 1/2” Carriage Bolts (1) in
the Stabilizer (5). Hand-tighten two 5/16”
Nylon Locknuts (3) onto the Carriage Bolts.	5	1
Do not tighten the Nylon Locknuts yet.
				100
Attach the other end of the Rear Seat Frame		11
(100) to the Leg Press Upright (56) with two
	56			3
5/16” x 2 3/4” Bolts (11), two 5/16” Flat
Washers (8), and two 5/16” Nylon Locknuts (3).	8
Attach the Handle (82) to the Rear Seat
Frame (100) with two 5/16” x 2 1/2” Carriage	3	3
Bolts (1) and two 5/16” Nylon Locknuts (3).				82
Tighten all Nylon Locknuts used in steps		1	5
1–5.
6. Set two Weight Bumpers (19) on the bracket	6
on the Base (4), as shown. Set two Weight
	Pin
Bumpers on the bracket on the Stabilizer (5).
	Grooves
Stack ten Weights (25) onto the bracket on
the Stabilizer (5). Stack eight Weights onto
the bracket on the Base (4). Be sure that the		25
pin grooves are all on the indicated side of	25
each stack of Weights.
Be careful not to tip either stack of		19		Pin
Weights (25) until step 8 is complete.	5—Bracket
				Grooves
		4—Bracket		19
6