Weider WESY96400 user manual that the Cable Trap is inside the Long “U”

CABLE ASSEMBLY

22. See the inset drawing. Attach a 3 1/2” Pulley	22
(15) and a Cable Trap (66) to the upper hole in
a Long “U”-Bracket (57) with a 3/8” x 2” Bolt		58
(12) and a 3/8” Nylon Locknut (21). Be sure
that the Cable Trap is inside the Long “U”-
Bracket. Note: This may come pre-assem-	66	15
bled.
Route the High Cable (58) through the Long	21				15
“U”-Bracket (57) and the 3 1/2” Pulley (15)	57	12			58
shown in the inset drawing. Be sure that the
Cable is in the groove of the Pulley and that
the Cable and Pulley move smoothly.		57
23. Wrap the High Cable (58) around a 3 1/2”	23
Pulley (15). Attach the Pulley to the bracket on
		Bracket			12
the Top Frame (55) with a 3/8” x 2” Bolt (12)			58
	55
and a 3/8” Nylon Locknut (21). Be sure that
the Cable is in the groove of the Pulley and					15
that the Cable and Pulley move smoothly.
	21
24. Note: This assembly step shows how to	24
complete the assembly of several pre-
attached parts.
The 5/8” x 9/16” Spacer (7) has been pre-
attached on the outside of the 3 1/2” Low
Pulley (76) for shipping purposes. Remove the
3/8” Nylon Locknut (21), the Spacer, and the
Pulley from the 3/8” x 3 3/4” Bolt (88). Do not
remove the Bolt. The Bolt has been shown
removed for part identification.
Reattach the 3 1/2” Low Pulley (76), with the
5/8” x 9/16” Spacer (7) between the Pulley and
the Press Frame (17). Do not tighten the 3/8”
Nylon Locknut (21) yet. Be sure that the
3/8” x 3 3/4” Bolt (88), the 3/8” Flat Washer				9	88
(9), the 5/8” x 9/16” Spacer (7), the 3 1/2”
Low Pulley (76), and the 3/8” Nylon Locknut
(21) are oriented as shown.					7
			17		76
					21

13