Weider WESY96400 user manual Cable Assembly

CABLE ASSEMBLY

34. See inset drawing A. Attach a 3 1/2” Pulley	34
(15) and a Cable Trap (66) to the upper hole					15	A
in the Long “U”-Bracket (57) with a 3/8” x 2”
Bolt (12) and a 3/8” Nylon Locknut (21). Be				21		66
sure that the Cable Trap is inside the Long
“U”-Bracket. (Note: This may come pre-
assembled.)				57	12
Route the Military Press Cable (72) through
the Long “U”-Bracket (57) and the 3 1/2”						B
Pulley (15). Be sure that the Cable is in the
groove of the Pulley and that the Cable				11	101
and Pulley move smoothly.
See inset drawing B. Slide a 5/16” Flat				8
Washer (8) onto a 5/16” x 2 3/4 Bolt (11).		15	57
Insert the Bolt through the Pivot Arm (101)
from the indicated side. Tighten a 5/16” Nylon		72
Jam Nut (93) onto the Bolt. Slide the end of
						93
the Military Press Cable (72) onto the end of
the Bolt. Thread another 5/16” Nylon Jam Nut						72
onto the Bolt. Do not fully tighten the sec-
ond Jam Nut. There must be room
between the two Jam Nuts for the end of
the Cable to pivot.
35. Locate the Leg Press Cable (99). Attach the	35
end of the Leg Press Cable to the Long “U”-
Bracket (57) with a 1/4” Nylon Locknut (2) and
a 1/4” Flat Washer (10). Do not completely
tighten the Nylon Locknut. It should be
threaded onto the end of the Cable only a
couple of turns, as shown in the inset
drawing.
Wrap the Leg Press Cable (99) around a			2
3 1/2” Pulley (15). Attach the Pulley to the Leg
Press Upright (56) with the 3/8” x 3 1/2” Bolt
(16), a 3/8” Flat Washer (9), and a 3/8” Nylon
Locknut (21). The ball on the Cable must be		10		57	56
on the indicated side of the Pulley. Be sure
					Ball
that the Cable and Pulley move smoothly			16
and that the Cable is between the Pulley				15
and the welded rod.
					9
			99
						21
				Welded
			2	Rod
			10
	99	57
17