Weil-McLain CGa-7, CGa-8, EG-55to EG-75, PEG-55, PFG-5, Gas valve - White-Rodgers36C, Position

Models: CGi PFG PEG LGB CGs EGH

1 24
Download 24 pages 40.3 Kb
Page 18
Image 18
•Gas valve — White-Rodgers 36C

CGa,CGi,CGs,EG,EGH,LGB,PEG,PFGBoilers

Operating instructions

Spark-ignited pilot

Gas valve White-Rodgers 36C

CGa-7, CGa-8, EG-55 to EG-75, PEG-55, PFG-5

FORYOUR SAFETY READ BEFORE OPERATING

If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.

A.This appliance is equipped with an ignition device which automatically lights the pilot. Do not try to light the pilot by hand.

B.Before OPERATING, smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor. See below.

C.Use only your hand to depress or turn the gas control knob. Never use tools. If the knob will not depress or turn by hand, don't try to repair it, call a qualified service technician. Force or attempted repair may result in a fire or explosion.

D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control, which has been under water.

WHAT TO DO IF YOU SMELL GAS

Do not try to light any appliance.

Do not touch any electric switch; do not use any phone in your building.

Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

If you cannot reach your gas supplier, call the fire department.

OPERATING INSTRUCTIONS

1.Stop! Read the safety information above on this label.

2.Set the thermostat to lowest setting.

3.When equipped with Effikal vent damper Model RVGP, place service switch in Hold Damper Open position.

4.Turn off all electrical power to the appliance.

5.When equipped with Johnson Controls vent damper Model M35, manually rotate damper blade in direction of arrow to Open position indicated on damper assembly.

6.This appliance is equipped with an ignition device which automatically lights the pilot. Do not try to light the pilot by hand.

7.Depress gas control knob slightly and turn clockwise CGa-7, CGa-8, EG-55 to EG-75, PEG-55, PFG-5 to OFF. Note: Knob cannot be turned to OFF unless knob is depressed slightly. Do not force.

Position

 

Gas

indicator

 

control

(shown in

 

knob

ON position)

 

 

59330

 

 

 

 

8.When equipped with vent damper, verify damper blade is in full open position.

9.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow "B" in the safety information above. If you don't smell gas, go to the next step.

10.Turn gas control knob counterclockwise Position to ON.

11.Turn on all electric power to the appliance.

12.When equipped with Effikal vent damper, place service switch in Automatic Operation position.

13.Set thermostat to desired setting.

14.If the appliance will not operate, follow the instructions

To Turn Off Gas To The Appliance and call your service technician or gas supplier.

15. Replace front panel.

TOTURN OFF GASTOTHE APPLIANCE

1.Set the thermostat to lowest setting.

2.Turn off all electric power to the appliance if service is to be performed.

3.Remove front panel.

4.Depress gas control knob slightly and turn clockwise indicator to OFF. Do not force.

5.Replace front panel.

18

Part Number 550-110-592/1000

Page 18
Image 18
Weil-McLain CGa-7, CGa-8, EG-55to EG-75, PEG-55, PFG-5, Gas valve - White-Rodgers36C, Operating instructions, Position