TROUBLESHOOTING SUGGESTIONS
SYMPTON | POSSIBLE CAUSE | SUGGESTED REMEDY | |
|
|
| |
Won’t heat- - no indicator | Not plugged in, or | Check plug | |
lights | Circuit breaker tripped. | Check / reset circuit breaker | |
One or more section | Temperature control not set | Set temperature control knob to | |
won’t |
| desired temperature | |
enough |
|
| |
240V unit run on 208V | Verify proper voltage | ||
| |||
|
|
| |
| Damaged component or wiring | Contact an Authorize Wells | |
|
| Service Agency for repairs | |
|
|
| |
One or more section too | Temperature control not set | Set temperature control knob to | |
hot |
| desired temperature | |
| 208V unit run on 240V | Verify proper voltage | |
|
|
| |
| Damaged component or wiring | Contact an Authorized Wells | |
|
| Service Agency for repairs | |
Element assy loose, or | Damaged hinge | Contact an Authorized Wells | |
difficult to raise or lower | (see page 7 for precautions) | Service Agency for repairs | |
|
|
| |
Element assy does not | Damaged support rod assembly | Contact an Authorized Wells | |
latch in up position |
| Service Agency for repairs |
10
