PREPARE THE CHAR-BROILER FOR USE
When using the broiler for the first time, wipe the entire unit with a clean damp cloth or sponge and mild detergent. Rinse thoroughly clean water. Dry with a soft clean cloth.
Remove the GRATE and raise the
ELEMENT ASSEMBLY.
Install the DRIP PAN and add 2 inches (5cm) of tap water.
Release the ELEMENT SUPPORT ROD by lifting the element assembly slightly, then pulling the lower portion
of the support rod forward. Lower the Fig. 3 ELEMENT SUPPORT ROD ELEMENT ASSEMBLY gently.
OPERATION
CAUTION:
Hot Surface
Exposed surfaces can be hot to the touch and may cause burns.
IMPORTANT: DO NOT attempt to raise the element assembly without first removing the grate. Damage to the hinges will result. Such damage is NOT covered by warranty.
IMPORTANT: Allow drip pan to cool before removing from the broiler.
DO NOT operate the broiler
MODEL
MODELS
ABOVE: Gently lower grate over elements. The end with flush tabs goes toward the front.
BELOW: Install one wing bolt in each tab. The notch in the wing rests on the lip of the drip pan. The end with flush tabs must go toward the front Adjust the wing bolts so that , when the element assembly is lowered, the top of the element is 1/4" (6mm) below the top of the grate fins.
ELEMENT
HANDLE
FRONT
GRATE TANG
Fig. 4
without the drip pan installed. DO NOT operate the broiler without 2” (5cm) of water in the drip pan.
IMPORTANT: DO NOT attempt to lower the element assembly without first releasing the support rod. Damage to the hinges will result. Such damage is NOT covered by warranty.
Fig. 5
7
