Weslo WETL34709.0 user manual Troubleshooting, Problem The power turns off during use

TROUBLESHOOTING

Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please see the front cover of this manual. PROBLEM: The power does not turn on

SOLUTION: a. Make sure that the power cord is plugged into a properly earthed outlet (see page 8). Do not use
an extension cord.
b. After the power cord has been plugged in, make sure that the key is inserted into the console.
c. Check the on/off switch located on the treadmill	c
frame near the power cord. If the switch protrudes
as shown, the switch has tripped. To reset the	Tripped	On
switch, wait for five minutes and then press the
switch back in.

PROBLEM: The power turns off during use

SOLUTION: a. Check the on/off switch (see the drawing above). If the switch has tripped, wait for five minutes and then press the switch back in.

b.Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five minutes, and then plug it back in.

c.Remove the key from the console. Reinsert the key into the console.

d.If the treadmill still will not run, please see the front cover of this manual.

PROBLEM: The walking belt slows when walked on
SOLUTION: a. If the walking belt is overtightened, treadmill perfor-	a
mance may decrease and the walking belt may be-		2–3 in.
come damaged. Remove the key and UNPLUG
THE POWER CORD. Using the hex key, turn both
idler roller bolts counterclockwise, 1/4 of a turn.
When the walking belt is properly tightened, you
should be able to lift each edge of the walking belt
2 to 3 in. (5 to 7 cm) off the walking platform. Be
careful to keep the walking belt centered. Then,
plug in the power cord, insert the key, and run the		Idler Roller Bolts
treadmill for a few minutes. Repeat until the walk-
ing belt is properly tightened.

b. If the walking belt still slows when walked on, see the front cover of this manual.

14