16westinghouse
After the check, switch on the appliance. The program continues from the point of in- terruption. If the malfunction occurs again, contact your Customer Care Centre.
If the display shows an alarm code, not de- scribed in the chart, contact your Customer Care Centre.
When you contact the Customer Care Cen- tre you will need to give some details of the appliance that can be found on the rating plate (e.g. model number, serial number, product number). We recommend that you record these details.
THE WASHING RESULTS AND DRYING RESULTS ARE NOT SATISFACTORY
Problem
The dishes are not clean.
There are streaks, milky stains, or a bluish layer on glasses and dishes.
Dry water drop stains on glasses and dishes.
The dishes are wet and dull.
The dishes are wet.
Possible cause
The selected washing program was not suitable for the type of load and soil.
The baskets were not loaded correctly, water did not touch all surfaces.
The spray arms could not turn freely because of incorrect ar- rangement of the load.
The filters are dirty or not as- sembled and installed correctly.
The quantity of detergent was not sufficient or missing.
Rinse aid dosage is too high.
Rinse aid dosage is too low.
The detergent can be the cause.
The rinse aid dispenser is emp- ty.
You have set a washing pro- gram without drying phase or with a decreased drying phase.
Possible solution
Make sure that the washing program is suitable for the type of load and soil.
Load the baskets correctly.
Make sure that an incorrect ar- rangement of the load does not cause a blockage of the spray arms.
Make sure that the filters are clean and correctly assembled and installed.
Make sure that the quantity of detergent is sufficient.
Decrease the rinse aid dosage.
Increase the rinse aid dosage.
Use a different brand of deter- gent.
Fill the rinse aid dispenser with rinse aid.
Leave the door ajar for some minutes before you remove the dishes.
