18westinghouse
If the door does not close correctly, loosen or tighten the adjustable feet to level the ap- pliance.
WATER CONNECTION
WATER INLET HOSE
Connect the appliance to a cold water sup- ply.
Connect the inlet hose to a water tap with an external BSP thread spout of 3/4”. Once connected the inlet hose to the water tap, turn the tap on and check that there are no leaks.
Inlet water supply
•Cold water pressure: 800 kPa max - 50 kPa min.
•Water flow rate 10 L / minute min.
•If cold water pressure is in excess of 800 kPa, a pressure reducing valve should be used. Check for leaks.
Caution! Always use new hoses when you connect the appliance to the water mains. Old hoses must not be used.
The water inlet hose must be examined at an interval of twelve months for deterioration and replaced if necessary.
The water pressure must be in the limits, refer to 'Technical data'.
Make sure that the local water authority gives you the average mains pressure in your area.
Make sure that the water inlet hose is not bent or squashed.
Fit the hose nut correctly to prevent water leaks.
Caution! Do not connect the appliance to new pipes or pipes that have been not used for a long time. Let the water run for some minutes, then connect the inlet hose.
WATER DRAIN HOSE
The highest point of the drain hose must be no more than 600 mm from the floor and must have a continuous fall to the plumbing connection.
The drain hose can be lengthened using additional lengths and connectors. These must be purchased from Electrolux Spare
Parts. The extension length must not ex- ceed 2 metres.
The drain hose must be free of obstruc- tions.
Remove the sink plug when the appliance drains the water to prevent that the water goes back into the appliance.
If you connect the water drain hose to a trap spigot under the sink, remove the plas- tic membrane. If you do not remove the membrane, remaining food can cause a blockage in the drain hose spigot.
The appliance has a security feature to prevent dirty water going back into the appliance. If, the spigot of the sink has a
Caution! Make sure that the water couplings are tight to prevent water leakage.
Ensure that hoses are not bent or squashed under or behind the appli- ance.
