7
7
OPERATING INSTRUCTIONS
1. Prepare recipe according to instructions. Place food in Ceramic Liner
and cover with the Glass Lid. Do not fill the Ceramic Liner to the
brim with food. Always cook with the Lid on and the Liner in posi-
tion. Remember that frequent lifting of the Lid during cooking delays
cooking time. When cooking a meat and vegetable combination,
place the vegetables in the bottom of the Liner first. Then add the
meat and other ingredients. If the Liner is hot, DO NOT add cold
food and vice versa. The Ceramic Liner cannot stand the shock of
sudden temperature changes.
2. Plug into a 120V AC outlet.
3. Turn Control Knob to the desired cooking setting, HIGH or LOW.
After cooking is complete WARM setting can be used.
CAUTION: COOKING BASE WILL GET VERY WARM DURING
COOKING. THIS IS WHERE THE HEATING ELEMENT IS
LOCATED. IF NECESSARY TO HANDLE, USE POT HOLDERS OR
OVEN MITTS.
4. Cook according to recipe instructions.
5. When cooking time is complete, turn Control Knob to OFF position
and unplug from outlet or turn to WARM for a short time. When
food is ready to be served, turn Control Knob to OFF and unplug
from outlet.
6. Using oven mitts, carefully remove the Glass Lid by grasping the Lid
Knob and lifting the Lid slightly away from you. This will allow the
steam to escape before removing the Lid.
7. Allow a few seconds for all steam to escape. Then, using oven mitts,
remove the Ceramic Liner from the Cooking Base.
8. Even when switched OFF, and unplugged, the Slow Cooker remains
hot for some time after using; set
aside and allow unit to cool before
cleaning or storing.
9. Allow to cool completely before
cleaning, see CARE AND
CLEANING.
NOTE: If you are moving the
Slow Cooker, grasp the unit by
the Cooking Base Handles; use
pot holders or oven mitts.
MODE D’EMPLOI
1. Préparer les recettes en suivant les instructions. Placer les aliments
dans le récipient et mettre le couvercle. Ne pas remplir le récipient à
ras bord. La récipient et le couvercle doivent toujours rester en place
pendant la cuisson. Soulever trop fréquemment le couvercle pendant
la cuisson augmente le temps de cuisson. Si la recette comprend une
combinaison d’ingrédients, placer les légumes dans le fond, puis la
viande et les autres ingrédients. Si le récipient de céramique est
chaud, NE PAS y mettre d’ingrédients froids, car il ne résistera pas
aux changements brusques de température.
2. Brancher sur une prise c.a. de 120 volts.
3. Placer la commande à la position désirée pour une cuisson à
température élevée (HIGH) ou faible (LOW). Une fois la cuisson
terminée, le réglage réchaud (WARM) peut être utilisé.
MISE EN GARDE : LA BASE CHAUFFANTE DEVIENDRA TRÈS
CHAUDE DURANT LA CUISSON, CAR ELLE CONTIENT
L’ÉLÉMENT. AU BESOIN, UTILISER DES POIGNÉES OU DES
MOUFLES ISOLANTES POUR MANIPULER L’APPAREIL.
4. Suivre les instructions de cuisson pour chaque recette.
5. Une fois la cuisson terminée, tourner la commande à OFF et
débrancher l’appareil ou le régler à la fonction réchaud (WARM)
pour une courte période. Lorsque la préparation est prête pour le
service, tourner la commande à OFF et débrancher l’appareil.
6. Après avoir enfilé des moufles isolantes, retirer le couvercle de verre
en saisissant le bouton et en dirigeant le couvercle loin de soi afin de
laisser la vapeur s’échapper.
7. Retirer complètement le couvercle et laisser la vapeur s’échapper
encore quelques secondes. À l’aide des moufles isolantes, retirer le
récipient en céramique de la base chauffante.
8. Même si le bouton est à OFF et que le cordon est débranché, la
mijoteuse reste chaude un certain temps après l’utilisation. La laisser
refroidir avant de la nettoyer ou
de la ranger.
9. Laisser refroidir complètement
avant de nettoyer (voir
NETTOYAGE DE LA MIJOTEUSE).
NOTE : S’il faut déplacer la
mijoteuse, mettre des poignées
ou des moufles isolantes et
saisir les poignées de la base
chauffante.
WST3011ZE_IB_29-4-03_CrP4 4/29/03 1:55 PM Page 13