I
The water dispenser
Chilled water comes from a tank behind the meat drawer. It holds approximately 1l/2 quarts (1.5 L).
When the refrigerator is first hooked up, press the water dispenser bar with a glass or jar until you draw and discard 2 or 3 quarts (1.9 to 2.8 L). The water you draw and discard rinses the tank and pipes.
Allow several hours to chill a new tankful.
NOTE: The small tray beneath the dispenser
is designed to evaporate small spills. There is no drain in this tray. Do not pour water into it.
To dispense water:
1.Press a sturdy glass against the water dispenser bar.
2.Remove the glass to stop dispensing.
NOTE: Dispense enough water every week to maintain a fresh supply.
The dispenser light
To turn on night light, slide dispenser LIGHT switch to the left. See page 21 for directions for changing the dispenser light bulb.
ON Off
e .
Solving common ice dispenser problems
1PROBLEM
Ice dispenser will not work
Ice dispenser stops working
POSSIBLE CAUSE/SOLUTION
l Freezer door is open.
l Ice bin not properly installed. Make sure the bin is pushed in all the way.
l Wrong ice in bin. Only use crescents from the ice maker. Shake the bin occasionally to separate cubes and increase storage room.
l Dispenser not used for extended periods of time, causing ice cubes to melt together. Dump old ice and make a new supply-
l Ice dispenser bar held in too long. Wait about 3 minutes for dispenser motor to reset.
l Large amounts of ice should be taken from the bin, not through the dispenser.
13