Now start...
With dryer in laundry area...
1 n Put on safety glasses and gloves. Take tape off front corners of dryer.
2 MOpen dryer and remove literature and parts packages. Remove parts from packages.
Check that all parts were included.
3 wRemove the tape that holds the drum to the cabinet. (Some dryer drums are not taped for shipping.)
Move the drum by hand to make sure all tape has been removed. Wipe the interior of the drum thoroughly with a damp cloth, Remove tape from the lint screen.
4 nTake two of the cardboard corners from the carton and place them on the floor in back of the dryer.
5 .Firmly grasp the body of the dryer and gently lay it on its back on the cardboard corners.
6 nWith one of the legs in hand, check the ridges for a diamond marking. That’s how far the leg is supposed to go into the hole.
7 nStart to screw the leveling legs into the holes by hand. (Use a small amount of liquid detergent to lubricate the screw threads so it is easier to turn the legs,) Use a
8 nStand the dryer up.
Slide dryer onto cardboard or hard- board before moving across floor to avoid damaging floor covering.
9 n Move dryer close to final position. Remove cardboard or hardboard from under dryer.
10 nCarefully move dryer into tinal position. Place level on top of the dryer, first side to side; then front to back. If the dryer is not level, adjust the legs of the dryer up or down until the dryer is level.
11 nTO exhaust dryer, see “Exhaust requirements,”
12 nPlug power supply cord into grounded outlet or connect power supply cable.
13 mlnsert user card and push START button. Using a full heat cycle (not the air cycle), let the dryer run for at least five minutes. Open dryer and check that there is heat.
Note: Dryer door must be closed for dryer to operate. When door is open, dryer stops, but timer continues to run. To restart dryer, close door and push START button.
Page 10
