Moving the dryer
to a new location...
Slide dryer onto cardboard or hardboard before moving across floor to avoid damaging floor covering.
Gas dryer models:
l Disconnect power supply cord. Tape securely to dryer.
l Shut off the gas supply valve in the gas supply line.
l Disconnect gas pipe and fittings from dryer and cap gas supply line. Tape end of dryer gas pipe.
Before installing gas dryer in a new location, check with your gas supplier or dealer to see that your dryer is equipped with the correct burner for the particular type of gas in your new building. Burner information may be found on the rating plate in the door well of the dryer.
Electric dryer models:
l Shut off electrical supply to dryer.
l Disconnect the power supply cord or cable from the dryer terminal block.
All models:
l Make sure leveling legs are secure in dryer base.
l Tape drum to front panel.
l Tape dryer door and lint screen.
I 4
Ir
If dryer does not
operate...
Check the following to be sure that: 1, Electrical supply is connected.
2.Circuit breakers are not tripped or house fuses blown.
3.Door is closed.
4.User card has been inserted.
5.START button has been pushed.
6.For gas dryers, check that gas supply line shutoff valve is set in open position.
If you need
assistance...
The Whirlpool Consumer Assistance Center will answer any questions about operating or maintaining your dryers not covered in the Installation Instructions. The Whirlpool Consumer Assistance Center is open 24 hours a day, 7 days a week. Just dial
When you call, you will need the dryer model number and serial number. Both numbers can be found on the model/serial rating plate located in the door well behind the dryer door and on the front of opening.
| T&f+1 | 01 |
|
| |
| 4a | CORPORATION |
|
| |
Part No. 3406449 |
|
|
| ||
|
|
| Printed in U.S.A | ||
0 1997 Whirlpool Corporation | Prepared by Whirlpool Corporation, | Benton Harbor, Michigan | 49022 | ||
|
