Whirlpool 910 Series Selecting cycle options, Changing a cycle setting, High Temp Wash, Air Dry

HIGH TEMP

WASH

AIR

DRY

SETTING THE CONTROLS

Selecting cycle options

If desired, press one or more Option pads. You can press an Option pad after the dish- washer starts as long as the cycle has not passed the point that the option is used. For example, you can press Air Dry any time before the Cycle Control knob reaches Dry.

High Temp Wash

When High Temp Wash is selected, the dishwasher heats the water during the main wash of the Light and Normal cycles. Heating the water helps improve

washing results. The Pots-N-Pans cycle automatically uses High Temp Wash.

NOTE: The Cycle Control knob does not move while water is being heated. Once the water reaches the proper temperature, the Cycle Control knob will begin moving again.

Air Dry

When Air Dry is selected, the air in the

dishwasher is not heated during the “dry” portion of a cycle. Using Air Dry helps save energy, but dishes take longer to dry and some spotting can occur. Some

items (such as plastics) may need towel drying. For best drying, use a liquid rinse agent.

NOTES:

•The dishwasher automatically heats the air in the dishwasher during the “dry” portion of the cycle unless you select Air Dry.

•Always select the Air Dry option when using the Rinse Only cycle.

Changing a cycle setting

You can change a cycle setting anytime during any cycle.

1.Lift up the door latch to stop the cycle.

2.Turn the Cycle Control knob clockwise to the desired cycle.

3.If desired, press one or more Option pads.

4.Check the detergent dispensers. They must be filled properly for the new cycle.

NOTE: Turning the Cycle Control knob can cause the covered section of the detergent dispenser to open and release the detergent. Check the covered section if setting a cycle.

5.Close the door firmly until it latches. The dishwasher starts the new cycle.

Changing an option setting

You can change option settings anytime

		during a cycle as long as the
	RESET	cycle has not passed the point
		that the option is used. For
		example, you can press Air
		Dry anytime before the Cycle
Control knob reaches Dry.

1.Press the Reset pad.

2.Press 1 or more Option pads.

14