Whirlpool 98012565 manual Oven Light, Oven Door, Removing the Oven Bottom, Oven And Roasting Rack

Models: 98012565

1 32
Download 32 pages 13.66 Kb
Page 13
Image 13
OVEN DOOR GLASS (on some models)

Steel wool pad

Oven cleaner:

Follow product label instructions. Do not let cleaner contact gasket, thermostat or exterior surfaces. Line the floor with newspaper.

OVEN DOOR GLASS (on some models)

Glass cleaner and paper towels or non-abrasive plastic scrubbing pad

OVEN AND ROASTING RACK

Steel wool pad

Oven Light

The oven light is a standard 40-watt appliance bulb. It will come on when the oven door is open. When the oven door is closed, press the manual oven light switch on the backguard to turn on and off.

Before replacing, make sure the oven and cooktop are cool and the control knobs are off.

To Replace:

1.Unplug range or disconnect power.

2.Turn bulb counterclockwise to remove from socket.

3.Replace bulb.

4.Plug in range or reconnect power.

To Replace:

1.Grasp the door on the sides with your fingers on the front of the door and your thumbs on the inside surface.

2.Hold oven door so that the top edge of each door slot is horizontal. Insert door hinge into the hinge slots.

3.Tilt top of door toward range. Insert bottom door hinge notch down onto front frame edge.

4.Open the door completely and remove the hinge pins. Save hinge pins for future use.

5.Close the door slowly to assure door side panel clearance and proper hinge engagement.

Oven Door

For normal range use, it is not suggested to remove the oven door. However, if necessary, follow these instructions. The oven door is heavy.

To Remove:

1.Open the oven door. Insert hinge pins, included with your range, into both hinge hangers. Do not remove the pins while the door is removed from the range.

2.Grasp the door on the sides with your fingers on the front of the door and your thumbs on the inside surface.

3.Pull door straight up, then toward you. Do not remove hinge pins until the door is replaced on the range.

Removing the Oven Bottom

The oven bottom can be removed for standard cleaning of the oven.

Before cleaning, make sure the oven is completely cool.

To Remove:

1.Remove the oven racks.

2.Place fingers in the slots in the bottom panel.

1.Lip

3.Lift the rear of the panel up and back.

The lip at the front of the panel should clear the front frame of the oven cavity.

4.Lift the bottom up and out.

To Replace:

Reverse the steps above.

13

Page 13
Image 13
Whirlpool 98012565 Oven Light, Oven Door, Removing the Oven Bottom, OVEN DOOR GLASS on some models, Oven And Roasting Rack