12
Air conditioner runs
for a short time only,
but room is not cool
■Set temperature is close to
room temperature. Lower set temperature. See “Using the Controls.”
Air conditioner runs, but does not cool ■The filter is dirty or
obstructed by debris. Clean the filter.
■Air outlet is blocked. Clear air outlet.
■Set temperature is too high. Lower set temperature.
■The air conditioner has lost
charge (leak in system), or
operated in temperatures
below 64ºF (18ºC).
If the control buzzer beeps 3 times repeatedly, contact service technician.
Air conditioner cycles on and off too much■The air conditioner is set to
ComfortMode™ control. Use ComfortMode™ control only when you are asleep or away from home,
since the fan does not circulate the room air continuously.
■The air conditioner is not
properly sized for your
room.
Check the cooling capabilities of your portable air conditioner. Portable air
conditioners are not designed to cool multiple rooms.
■The filter is dirty or
obstructed by debris. Clean the filter.
■There is excessive heat or
moisture (open container
cooking, showers, etc.) in
the room.
Use a fan to exhaust heat or moisture from the room. Try not to use heat-
producing appliances during the hottest part of the day.
■The louvers are blocked. Install the air conditioner i n a location where the louvers are free from curtains,
blinds, furniture, etc.
■The outside temperature is
below 64°F (18°C). Do not try to operate your air conditioner in the cooling mode when the outside
temperature is below 64°F (18°C).
■The temperature of the
room you are trying to cool
is extremely hot.
Allow extra time for the air conditioner to cool off a very hot room.
■Windows or doors to the
outside are open. Close all windows and doors.
Temperature on
display does not
match room
temperature
■When the compressor and
fan motor turn off during
Power Saver mode, or after
you turn off the unit, a lower
temperature reading than
the actual room
temperature may be
displayed for a short period
of time.
This lower temperature reading is caused by the temperature sensor being
located close to the cold evaporator coil. The actual room temperature will
display within a few minutes.
Water dr ips from cabinet into your house■The drain plug is not
installed properly. Install drain plug properly.
Water Full indicator remains on, and the air conditioner turns off■This is normal. See “Portable Air Conditioner Care” for instructions on how
to drain the air conditioner.
Problem Possible Cause Solution