Whirlpool ACQ062MP0 Mode, Timer Delay, Fan Speed, Temperature, To keep the previous settings

Mode

1.Press and hold MODE.

2.Choose AUTO, COOL, FAN or POWER SAVER.

■Auto - Automatically controls fan speed while cooling room. The fan speed cannot be changed, but the temperature can be adjusted by pressing the up or down arrow button.

■Cool - Cools room. Press FAN SPEED to choose fan speed. Then adjust the temperature by pressing the up or down arrow buttons.

■Fan - Operates the fan at Turbo speed, without cooling. The display shows “FO” (fan only).

■Power Saver - Fan and compressor run only when cooling is needed. Turns fan off when room temperature reaches the temperature setting on the thermostat.

Timer Delay

To set the Timer for a 1- to 24-hour delay until the air conditioner turns on (the air conditioner must be Off):

1.Press TIMER. Indicator light will flash.

2.Press the up or down arrow button to change the delay time from 1 to 24 hours.

3.Press TIMER or wait 10 seconds. Indicator light will remain on.

To set the Timer delay for a 1- to 24-hour delay until the air conditioner turns off (air conditioner must be On):

1.Press TIMER. Indicator light will flash.

2.Press the up or down arrow button to change the delay time from 1 to 24 hours.

3.Press TIMER or wait 10 seconds. Indicator light will remain on.

Fan Speed

NOTE: The Fan Speed button will operate only when the Cool or Power Saver mode has been selected.

1.Press and hold FAN SPEED until you see the indicator light for the desired setting.

2.Choose TURBO, HIGH or LOW.

Temperature

■Press, or press and hold, the up arrow button to raise the temperature 1ºF (0.56ºC) until it reaches 86ºF (30ºC).

■Press, or press and hold, the down arrow button to lower the temperature 1ºF (0.56ºC) until it reaches 64ºF (18ºC).

To keep the previous settings

1.Turn off air conditioner.

2.Press TIMER. Indicator light will flash.

3.Press the up or down arrow button to change delay time from 1 to 24 hours.

4.Press TIMER or wait 10 seconds.

To change the previous settings

1.Turn on air conditioner.

2.Adjust MODE to desired setting.

3.Adjust FAN SPEED to TURBO, HIGH or LOW.

4.Adjust temperature between 64ºF (18ºC) and 86ºF (30ºC).

5.Turn off air conditioner.

6.Press TIMER. Indicator light will flash.

7.Press the up or down arrow button to change delay time from 1 to 24 hours.

8.Press TIMER or wait 10 seconds.

To clear Timer delay program

NOTE: Air conditioner can be either on or off.

Press and hold TIMER for 3 seconds. Indicator light will turn off.

To see the time remaining (in hours)

1.Press TIMER once after it has been set.

2.While the display is showing the remaining time, you can press the up or down arrow button to increase or decrease the time.

8