AIR CONDITIONER USE
Operating your air conditioner properly helps you to obtain the best possible results.
This section explains proper air conditioner operation.
IMPORTANT:
■If you turn off the air conditioner, wait at least 3 minutes before turning it back on. This prevents the air conditioner from blowing a fuse or tripping a circuit breaker.
■Do not try to operate your air conditioner in the cooling mode when outside temperature is below 65°F (18°C). The inside evaporator coil will freeze up, and the air conditioner will not operate properly.
NOTE: In the event of a power failure, your air conditioner will operate at the previous settings when the power is restored.
Starting Your Air Conditioner—
Digital Control
1.Remove clear protective film from control panel and front panel badge.
2.Press POWER to turn on air conditioner.
2.Choose AUTO, COOL, FAN ONLY or POWER SAVER.
■Auto - Cools room while it automatically controls fan speed. You cannot change fan speed, but you can adjust temperature by pressing the plus or minus button.
■Cool - Cools room. You can select fan speed by pressing Fan Speed. You can then adjust temperature by pressing the plus or minus button.
■Fan Only - Only the fan runs. Display shows “FO” (fan only).
NOTE: Fan runs on Turbo speed only.
■Power Saver - Fan runs only when cooling is needed. Fan stops running when the room temperature matches the Temperature control setting.
Because the fan does not circulate the room air continuously, less energy is used, but the room air is not circulated as often. Use Power Saver when you are asleep or away from home.
Fan Speed
NOTE: The Fan Speed button will operate only when Cool or Power Saver mode has been selected.
1.Press FAN SPEED until you see the indicator light come on for the setting you desire.
2.Choose TURBO, HIGH or LOW.
NOTE: When air conditioner is turned on for the first time
after it is plugged in, it will display the default settings: Cool mode, Turbo fan speed, 72°F (22°C). When it is turned on at all other times, it will display the previous settings.
3.Select mode. See “Mode.”
4.Select fan speed. See “Fan Speed.”
5.Set temperature. See “Temperature.”
Mode
1.Press MODE until you see the indicator light come on for the setting you desire.
Temperature
■Press the plus button to raise the temperature 1º until it reaches 86°F (30°C).
■Press the minus button to lower the temperature 1º until it reaches 64°F (18°C).
To change the temperature display from °F to °C:
1.Turn off the air conditioner.
2.While the air conditioner is off, press and hold down the MODE and FAN SPEED buttons while pressing POWER to turn the air conditioner on.
NOTE: Follow these same steps to change the temperature display from °C to °F.
8
