GETTING TO KNOW YOUR MICROWAVE OVEN
13.Number Pads. Touch Number pads to enter cooking times, cook powers, selection quantities or weight.
14.MINUTE TIMER. Touch this pad followed by number pads to use as a kitchen timer.
15.START/ENTER. Touch this pad to start a function that you have set.
16.ADD MINUTE. Touch this pad to cook for one minute at 100% cook power or to add an extra minute to your cooking cycle at current power.
17.OFF/CANCEL. Touch this pad to erase an incorrect command, to cancel a program during cooking, or to clear the display after a function is completed. This pad will not erase time of day.
NOTES:
•If you choose an automatic cooking func- tion and change your mind, you must press OFF/CANCEL before you choose another automatic cooking function.
•If you attempt to enter unacceptable instructions, three tones will sound, and “Err” will appear on the display. Touch OFF/CANCEL and
•Once you choose a function, an indica- tor light (▲) will flash as a prompt for the next action you need to perform.
•If you choose a function but do not press another command pad within one minute, the display returns to the time of day and you have to start over.
•If you have entered all settings for a function but do not touch START/ENTER in 5 seconds, the Start? indicator light will flash.
•If you open the door while the oven is on and then shut the door, the Start? indicator light will flash.
Audible signals
Audible signals are available to guide you when setting and using your oven:
•A programming tone will sound each time you touch a pad.
•Five tones signal the end of a cooking cycle and two tones will sound every minute until you open the door or press
OFF/CANCEL.
•Three tones will sound if you enter incorrect instructions.
Interrupting cooking
You can stop the oven during a cycle by opening the door. The oven stops heating and the fan stops, but the light stays on. To restart cooking, close the door and
TOUCH
If you do not want to continue cooking:
•Close the door and the light goes off.
OR
•TOUCH
NOTE: Before setting a function, touch OFF/CANCEL to make sure no other function is on.
11
