INSTALLING YOUR REFRIGERATOR
Connecting to refrigerator
1.While your refrigerator is away from the wall, remove and save the lower cover by removing the screws.
2.Remove the nut and sleeve from the adapter fitting and slide the brass nut and sleeve over the end of the copper tubing. Insert the copper tubing com- pletely into the adapter fitting and make sure that the hose washer is in place. Tighten the adapter fitting by hand as much as possible, then tighten 1/2 turn with an adjustable wrench. Make sure the copper tubing is secure by pulling on it gently.
3.Turn
4.Replace the lower back cover onto the refrigerator and replace and tighten the screws. Be sure to tuck wires inside the cover. Do not allow wires to be pinched.
5.Create a service loop with the copper tubing to avoid kinks and secure it to the refrigerator cabinet using the “P” clamp.
6.Plug in the refrigerator and recheck for leaks while it is running. Make sure that the water inlet tube in the freezer section stays firmly in place.
7.Reposition the refrigerator against the wall.
10
