Lighting standing pilots
(models FGP320Y, FGP320A, FLP320A, and FLP3lOY)
To light range pilots:
1.Make sure all controls are turned off.
2.Remove the surface burner grates from the cooktop. Lift the cooktop. (See “Lift- up cooktop” on page 18.)
3.To light, hold a lit match over the pilot light located between the front and back burners. The pilot flame should be l/4 to 3/ain
4.If the pilot flame needs adjustment, turn the pilot adjustment screw midway down the length of the manifold pipe, behind the control panel.
5.Lower the cooktop and replace the grates before using the surface burners.
To light oven burner pilot:
1.Make sure the Oven Temperature Control is turned off.
2.Remove the oven bottom (see “Remov- ing the oven bottom” on page 21). Then unscrew the burner baffle located on the burner (see Installation Instructions for more information about the baffle).
3.Hold a lit match over the oven burner pilot located at the rear of the burner.
4.After the oven burner pilot is burning steadily, check burner lighting by turning the Oven Temperature Control to a temperature above 140°F (60°C). The burner will take
5.Replace the burner baffle and oven bottom.
11
