Onkyo HTX-22HD Error Messages, To Retry the Automatic Speaker Setup, First Time Setup—Continued

First Time Setup—Continued

Error Messages

While the automatic speaker setup is in progress, one of the following error messages may appear:

❑Ambient noise is too high

This message appears if there’s too much background noise and the measurements can- not be performed properly. Remove the source of the noise and try again.

❑Speaker Detect Errors

This message appears if one of the speaker- related errors below occurs.

•One of the front speakers has not been detected.

•One of the surround speakers has not been detected.

•The surround back speakers have been detected but the surround speakers haven’t.

•The right surround back speaker has been detected but the left surround back speaker

hasn’t.

There is a problem with a speaker. One of the speakers is damaged, or the subwoofer is out- putting sound at the upper end of its range that is too loud.

❑Mismatch Error

•The number of speakers detected on the second or third measurement was different

to the number detected on the first mea- surement.

This message appears if a speaker that was detected during the 1st measurement is not detected during the 2nd or 3rd measurements. If this message appears, check your speaker connections, and then try again.

❑Write Error

This message appears if saving fails.

To Retry the Automatic Speaker Setup

Press the [ENTER] button.

Make sure speakers that cannot be detected are con- nected properly.

Changing the Speaker Settings Manually

You can change the settings manually if nec- essary (see pages 56–62).

35