Onkyo HTX-22HD instruction manual Installing the Batteries, Aiming the Remote Controller

Remote Controller

Installing the Batteries

1 Open the battery compartment, as shown.

2 Insert the two supplied batteries (AA/

R6) in accordance with the polarity diagram inside the battery compart- ment.

3 Close the battery compartment.

Notes:

•If the remote controller doesn’t work reli- ably, try replacing the batteries.

•Don’t mix new and old batteries or differ- ent types of batteries.

•If you intend not to use the remote control- ler for a long time, remove the batteries to prevent damage from leakage or corrosion.

•Expired batteries should be removed as soon as possible to prevent damage from leakage or corrosion.

Aiming the Remote Controller

When using the remote controller, point it toward the HTX-22HD’s remote control sen- sor, as shown below.

Remote control sensor

STANDBY indicator

Approx. 16 ft. (5 m)

30˚ 30˚

HTX-22HDPAW

Notes:

•The remote controller may not work reli- ably if the HTX-22HD is subjected to bright light, such as direct sunlight or inverter-type fluorescent lights. Keep this in mind when installing.

•If another remote controller of the same type is used in the same room, or the HTX- 22HD is installed close to equipment that uses infrared rays, the remote controller may not work reliably.

•Don’t put anything on top of the remote controller, such as a book or magazine, because a button may be pressed continu- ously, thereby draining the batteries.

•The remote controller may not work reli- ably if the HTX-22HD is installed in a rack behind colored glass doors. Keep this in mind when installing.

•The remote controller will not work if there’s an obstacle between it and the HTX-22HD’s remote control sensor.

14