Surface Burners
I | TYPICAL TOP BURNERFLAME |
Lift up the cooktop, following the instructions on page 15.
Wipe off surface burners with warm soapy water and a soft cloth after each use.
Occasionally check surface burner flames for size and shape as shown. If flames do not burn properly, you may need to remove the surface burners for cleaning (see pagel9), or call a qualified technician for burner adjustments.
To adJust the LO settings on the control knobs:
1. Turn on the surface burners, then set the controls on LO.
2.Without changing the burner settings, remove the control knobs.
3.Firmly grasp the control stem and insert a small bladed screwdriver into the end of the stem. Turn the screwdriver in either direction until the flame height is Yein. (3.2 mm] or lower in size. Flame must be large enough to malntaln a STABLEFLAME on all burner ports.
NEVERADJUST THEFLAME SIZEAT THEMEDIUM SEllING.
The Oven Door
Removing the oven door will make it easier to clean the oven.
Burn and Electrlcal Shock Hazard
Make sure all controls are OFF and the oven Is 11betore removlng oven door. Fallure to do
so can result In burns or electrlcal shock.
1. Open the door to the first stop position.
2.Hold the door at both sides and lift off of hinges at bottom corners of door.
3.To replace, fit the bottom corners of the door over the ends of the hinges.
Push the door down evenly. The door will close only when it is on the hinges correctly.
16
