Programming tone
Each time You touch a pad You will hear a tone. If You do not hear a tone, it is because the instruction is not correct, or it is because the tones have been removed.
EXAMPLE: If You forget to plug in the Temperature Probe and touch PROBE TEMP You will not hear a tone. The instruction is not correct.
If you want to remove the tone:
l Open the door.
l Touch CANCEL twice, then START
l The tone will not sound for any touch. If you want to replace the tone:
l Open the door.
l Touch CANCEL twice, then START.
l The tone will sound for any correct touch.
l The programming tone will return after an electrical power outage.
Other operating hints
These are a number of things You can do with Your microwave oven. Some will be reminders. Others will be mentioned for the first time.
1.To double check settings while the oven is running, touch the command pad for the
setting You want to check. The instruction programmed for that pad will show on the Display for 5 seconds. Then the Display will return to show what the oven is doing.
2.To stop the oven while it is running:
l Open the door. The oven will stop. You can restart it by closing the door and touching
START
l Touch CANCEL. All instructions will be erased. You must touch in new instructions.
3.If You touch two instructions into the same cycle, the second instructions will erase the first
4.When using a Cook Power other than high, the Display will show the Cook Power for 2 seconds of every10 during cooking.
5.When COOK follows QUICK DEFROST,a standing time equal to the defrosting time
will occur between the two. The COOK Cycle will automatically begin offer this standing time.
