4.Lift out the reflector bowl. See “Cleaning chart” on page 26 for cleaning instructions.
Replacing
1.Make sure all control knobs are turned
off and cool before replacing surface units and reflector bowls.
2.Line up openings in the reflector bowl with the surface unit receptacle.
3.Hold the surface unit as level as possible with the terminal just started into the receptacle.
4.While pushing the surface unit terminal into the receptacle, lift a little on the edge of the unit nearest the receptacle. When the terminal is pushed into the receptacle as far as it will go, the surface unit will fit into the reflector bowl.
00
0a
iill
18
