Whirlpool RF385PXY manual Method Z-Using Stop Time

To cancel the MEALTIMER” control setting:

l Push the Off/Cancel pad to return the display to the time of day.

Method Z-Using Stop Time:

1.Position the oven rack(s) properly and put food in the oven.

2.Make sure the clock is set to the correct time of day. (See “Setting the clock” on page 11.)

3.Push the Bake pad to enter the Bake mode.

Use the Temp pad(s) to set the desired temperature. Push A to raise the temperature or V to lower the temperature in 5°F incre- ments. Use these pads until the desired temperature shows in the small display.

After you have set the desired temperature, the display will show the set temperature and the time of day. BAKE will light up.

4.Push the Stop Time pad. The time of day with the colon flashing and STOP TIME will show in the display.

5.Use the Hour and Minute pads to set the desired stop time. Push the “up”(A) or “down”

(V)pad(s) until the correct time shows in the display.

This example shows a desired stop time of 2 o’clock. This provides a e-hour cook time (the difference between the time of day and the stop time).

6.Push the Start/Enter pad. “Lo”“,HEAT, TIMED and BAKE will light up in the display to indicate that the oven is heating.

NOTE: The display will show “door” and a tone will sound once a minute for 5 minutes if the door is latched when you try to bake/roast.

You can change the temperature or time settings any time after pushing the StatVEnter pad by repeating just Steps 3 through 5.

7.The display will count down the baking/ roasting time in minutes.

19