Whirlpool RJE-3165 Easier cleaning with aluminum foil, Cleaning under the cooktop, angle it is in

Hold surface unit level when replacing.

Replacinu reflector bowls and surface units:

Be sure the surface unit controls are on “OFF.”

Put the reflector bowls back into their places. Make sure you can see

the plug-ins (receptacles) for the surface units through the square hole in the side of each bowl.

Hold the surface unit level with the prongs (terminals) pointing at the plug-in

With the prongs started in the plug-in, start pushing in on the surface unit. At the same time. lift a little on the side of the surface unit that’s by the plug-in.

Make sure the surface-unit prongs are pushed into the plug-in as far as they will go. The surface unit should fit into the reflector bowl and be level

Foil should be flat on the bottom so should the feet on the element.

Prop up the top with support rod.

Easier cleaning with aluminum foil:

Oven cleaning can be a chore when spillovers bake onto the

bottom of the oven. Use aluminum foil so you can just throw it away with

the spillovers. You can use the heavy-duty 18.inch (45 cm) aluminum foil

found in most grocery stores. Or you can order an aluminum foil kit (Part

Number 241430) from wour Whirlpool Dealer.

1 When cutting the foil, make sure it is long enough to cover the bottom wtth enough left over to start up both sides.

2.Make sure the bake element is cool. Lift it far enough to raise its feet

from the bottom of the oven (You may have to remove the

oven

rack.

)

Slide

the

foil sheet

under

the bake

element.

Make

sure

it

1s centered

and long

enough

to start up the sides

When

you

put

the

bake

element

back

down,

make

sure

all

the

feet

rest

solidly

on

the

foil

and

that

the foil

is smoothed

out

across

the

bottom

of

the

oven

If

the

feet

on

the element

are

not

solidly

on

the

foil.

the

oven

may

not

bake

properly

Cleaning under the cooktop:

To clean the area under the cooktop. lift the front of the cooktop at the center. Raise the swing-up rod to hold it. (Be sure the tip of the rod is

in the notch in the cooktop.) Use warmsoapy water and a sponge or cloth.

Scouring powders or any other abrasive cleaner may harm porcelain- enamel finishes and can scratch chrome.

Be careful not to raise the cooktop so high that it touches the control console. And don’t drop it. Dropping the cooktop can chip or crack a hard porcelain ftnish. or damage side panels and surface unrts.

Removing the oven door:

Removing the oven door may make it easier to clean the oven. To

Pull straight with the remove the door, ftrst open it to the first stop (about 4 inches or 10 cm). angle of part-open door. Take hold of both sides of the door near the top, then lift it at the same

angle it is in.

With the door off, you will notice how the ends of the htnges slide Into slots at the bottom corners of the door. To put the door back on, fit both bottom corners of the door over the ends of the hinges. Push the door down evenly, so neither corner gets ahead of the other. When it reaches the bottom, you can close the door. A safety latch will hold the door open until it is on correctly.

Push down evenly.‘

10