REPLACING
Receptacle
I.Be sure surface unit controls are OFF.
2.Line up opening in the reflector bowl with the surface unit receptacle.
4.While pushing the surface unit terminal into
the receptacle, lift a little on the edge of the unit nearest the receptacle.
5.When the terminal is pushed into the re- ceptacle as far as it will go, the surface unit will fit into the reflector bowl.
3.Hold the surface unit as level as possible
with the terminal just started into the receptacle.
Reflector bowls reflect heat back to the utensils on the surface units. They also help catch spills. When they are kept clean, they reflect heat better and look new longer.
If a reflector bowl gets discolored, some of the utensils used may not be flat enough. Or some may be too large for the surface unit. In either case, some of the heat that is meant to go into or around a utensil goes down and heats the reflector bowl. This ex- tra heat can discolor it.
LIFT-UP COOKTOP
1.Lift the front of the cooktop at the center and swing the support rod up.
2.Carefully lowerthe cooktop onto the support rod. Be sure the tip of the rod fits in the notch in the cooktop.
3.Wipe with warm soapy water. Use soapy steel wool pad on stubborn spots.
DO NOT let the cooktop bump the upper oven when lifting. DO NOT drop the cooktop. Damage can result.
19
