Whirlpool SERIES 940 warranty Solving Common Dishwashing Problems, Solution, chart

Models: SERIES 940

1 31
Download 31 pages 41.31 Kb
Page 23
Image 23
Solving Common Dishwashing Problems

Solving Common Dishwashing Problems

Following is a convenient checklist for handling minor performance problems. Go over this list before calling for service. If you are unable to solve your dishwasher’s problem, turn to the “Troubleshooting” section for service information.

Solution

PROBLEM

Food soil left on dlshes

Spottlng and filming

chart

CAUSE

Improper loading

Water temperature too low

Use of incorrect, too little, or ineffective detergent

Detergent cakes in dispenser

lnsuff icient fill due to low water pressure

Slowdown of wash arm due to high suds

Hard water or high mineral content in water

Water temperature too low

Use of incorrect detergents

SOLUTION

See the “LoadingYour Dishwasher” section.

Use the High Temp Wash option. If needed, turn home water heater up to ensure water entering dishwasher is 120°F (49°C) mini- mum. See the “Tocheck water temperature” section.

NOTE: In some cases, loads may not dry as well when using the High Temp Wash option.

Use recommended dishwasher detergents only. See the “Usingthe Dispensers” section. Never use less than one tablespoon per load. Detergent must be fresh to be effective. Always store detergent tightly-closed in a cool, dry place.

Use fresh detergent only. Do not allow detergent to sit for several hours in a wet dispenser. Check dispenser for caked detergent. Clean dispenser when caked detergent is present.

Home water pressure should be 20 to 120 pounds per square inch (psi) for proper dish- washer fill. A booster pump on the water supply may be necessary if pressure is

too low.

Never use soap or laundry detergents. Use recommended dishwasher detergents only.

Use rinse agent to help prevent spotting and filming. See the “LoadingYour Dishwasher” section. To remove hard water film, see “Removingspots and film” at the end of this section.

Use the High Temp Wash option. If needed, turn home water heater up to ensure water entering dishwasher is 120°F (49°C) mini- mum. See the “Tocheck water temperature” section.

NOTE: In some cases, loads may not dry as well when using the High Temp Wash option.

Use recommended dishwasher detergents only.

continued an next aaae 2

Page 23
Image 23
Whirlpool SERIES 940 warranty Solving Common Dishwashing Problems, Solution, chart