ELECTRONIC OVEN CONTROL
B |
| C | E |
| S A |
| |
1. | Display | 4. | Auto Clean | 7. | Oven Settings | 10. | Timed Cooking |
2. | Timer | 5. | Oven Light Pad | 8. | Warming Drawer | 11. | Hour/Minute |
3. | Clock | 6. | Sequence Programming |
| (on some models) | 12. | Start/Control Lock |
9. |
| ||||||
|
|
| (on some models) | Temperature | 13. | Off/Cancel | |
|
|
|
|
|
|
Display
When power is first supplied to the appliance, “PF” will appear on the display. Press OFF/CANCEL to clear.
Any other time “PF” appears, a power failure has occurred. Press OFF/CANCEL and reset the Clock if needed.
When the oven is not in use, the display shows the time of day.
When using COOK TIME (on some models,) the display will show either hours and minutes, or minutes and seconds.
Tones
Tones are audible signals, indicating the following:
One tone
■Valid pad press
■Oven is preheated
■Function has been entered
Start
The START pad begins any oven function. If not pressed within 5 seconds after pressing a function pad, the “START?” indicator light will flash as a reminder. On some models, “START?” will appear on the display.
If not pressed within 4 to 5 minutes (depending on your model) after pressing a function pad, the oven display will return to the time of day mode and the programmed function will be cancelled.
Off/Cancel
The OFF/CANCEL pad stops any function except the WARMING DRAWER, Timer and Control Lock.
Clock
To Set:
Before setting, make sure the oven and Timer are off.
1.Press CLOCK.
2.Press the HR or MIN “up” or “down” arrow pads to set the time of day, including a.m. or p.m.
3.Press CLOCK or START.
Three tones
■Invalid pad press
Four tones
■
■Reminder, repeating each minute after the
Reminder Tones
Reminder tones may be turned off. Press and hold STOP TIME for 5 seconds. “rEP” will appear in the
All Tones
All of the above tones are preset on, all except the
To Turn Off/On: Press and hold START TIME for 5 seconds. A tone will sound and “Snd OFF” will appear on the display. Repeat to turn tones on and “Snd on” will appear on the display.
Tone Pitch (on some models)
The pitch is preset at high, but can be changed to low.
To Change: Press and hold WARMING DRAWER for 5 seconds. A tone will sound and “ Snd LO” will appear on the display. Repeat to change and “Snd Hi” will appear on display.
8
