Whirlpool SF302ESR, SF302BSR The Oven Vent, Lighting Standing Pilots, To Light Cooktop Pilots

The Oven Vent

Hot air and moisture escape from the oven through a vent located under the backguard. Do not block vent. Poor baking will result.

OVENVENT

Lighting Standing Pilots

To Light Cooktop Pilots:

1. Make sure all controls are OFF.

2.Remove the grates from cook-top. Lift the cooktop and rest on support rod.

To light Oven Burner Pilot:

1. Make sure the oven control is OFF.

2.Remove the broiler drawer. Slide drawer out to stops, lift both sides, then slide the rest of the way out.

3.To Ilght, hold a lit match over the pilot light located between the front and back burners. The pilot flame should be ti to 3/ein (.635-,953 cm) high.

4.If the pilot flame needs adjust- ment, turn the pilot adjustment screw on the manifold pipe.

5.Lower the cook-top and replace the grates before using the sur- face burners.

3.Hold a lit match overthe oven burner pilot located at the rear of the burner.

4.After the oven burner pilot is burn- ing steady, check burner lighting by turning the Oven Temp control knob to a temperature above 140°F(60°C). The burner will take 5060 seconds fo light.

5. Replace the broiler drawer. 9