3.Tilt top of door toward range. Insert bottom door hinge notch down onto front frame edge.
4.Open the door completely and remove the hinge pins. Save hinge pins for future use.
5.Close the door slowly to assure door side panel clearance and proper hinge engagement.
RemovingtheOvenBottom
The oven bottom can be removed for standard cleaning of the oven.
Before cleaning, make sure the oven is completely cool.
To Remove:
1.Remove the oven racks.
2.Place fingers in the slots in the bottom panel.
A
A.Lip
3.Lift the rear of the panel up and back.
The lip at the front of the panel should clear the front frame of the oven cavity.
4.Lift the bottom up and out.
To Replace:
Reverse the steps above.
TROUBLESHOOTING
Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.
Nothing will operate
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or electrical shock.
■Is the power outlet properly wired and polarized?
Try another outlet to check for proper wiring and polarity.
■Is the power supply cord unplugged? Plug into a properly grounded 3 prong outlet.
■Has a household fuse been blown, or has a circuit breaker tripped?
Replace the fuse or reset the circuit breaker. If the problem continues, call an electrician.
■Is the main or regulator gas shutoff valve in the off position?
See Installation Instructions.
■Is the range properly connected to the gas supply? Contact a trained repair specialist or see Installation Instructions.
Surface burners will not operate
■Is this the first time the surface burners have been used? Turn on any one of the surface burner knobs to release air from the gas lines.
■Is the control knob set correctly? Push in knob before turning to a setting.
■Are the burner ports clogged? See “Surface Burners” section.
Surface burner flames are uneven, yellow and/or noisy
■Are the burner ports clogged? See “Surface Burners” section.
■Are the burner caps positioned properly? See “Surface Burners” section.
■Is the air/gas mixture correct?
Contact a designated service technician to check the air/gas mixture, or see the Installation Instructions.
■Is propane gas being used?
The appliance may have been converted improperly. Contact a trained repair specialist.
Surface burner makes popping noises
■Is the burner wet? Let it dry.
Cookware not level on cooktop
■Is the range level?
Level the range. See the Installation Instructions.
■Is the proper cookware being used?
Use cookware with a flat bottom. See “Cookware” section.
12
