REFRIGERATOR USE
View Temperature Set Points
1.Press and hold TEMP for 3 seconds to activate Temperature mode.
NOTE: To view temperature in degrees Celsius, press the LIGHT button, under Units, when adjust mode is activated. To return the display setting to Fahrenheit, press the LIGHT button again.
When Temperature mode is activated, press TEMP to toggle between Fridge and Freezer. The display will show the temperature set point of the selected compartment, and temperature adjusting information will appear on the display screen.
Recommended Refrigerator Temperature
Recommended Freezer Temperature
Save/Confirm Temperature Settings
■When you have finished adjusting both the refrigerator and freezer set points, press MEASURED FILL to confirm and to save the settings.
NOTE: To exit Temperature mode without saving changes, press the ICE/WATER button under Back at any time, or allow about 60 seconds of inactivity. The temperature mode will turn off automatically and return to the normal screen.
When adjusting temperature set points,
use the following chart as a guide:
CONDITION: | TEMPERATURE |
| ADJUSTMENT: |
|
|
REFRIGERATOR too cold | REFRIGERATOR Setting |
| 1° higher |
|
|
REFRIGERATOR too warm | REFRIGERATOR Setting |
| 1° lower |
|
|
FREEZER too cold | FREEZER Setting |
| 1° higher |
|
|
FREEZER too warm / | FREEZER Setting |
Too little ice | 1° lower |
|
|
Cooling On/Off
Your refrigerator and freezer will not cool when cooling is turned off.
■To turn cooling off, press and hold the LOCK and MEASURED FILL buttons at the same time for 3 seconds. The Cooling Off icon will blink seven times and then remain lit as shown.
IMPORTANT:
■To avoid unintentionally locking the dispenser or changing other settings, press both buttons at exactly the same time.
■When cooling is off, the dispenser paddles and all controls except Lock and Measured Fill are disabled.
Adjust Temperature Set Points
Refrigerator set point range: 33°F to 45°F (0°C to 7°C).
Freezer set point range:
1.When Temperature mode is activated, press TEMPERATURE to select the Refrigerator zone. The display will show the temperature set point of the selected compartment, as shown.
2.Press LOCK to raise the set point, or press OPTIONS to lower the set point.
3.When you have finished viewing (and adjusting if desired) the refrigerator set point, press TEMP, under Select Zone, to change the display to show the freezer set point. When the zone has been changed, “FREEZER” appears on the display screen.
4.Press the LOCK button to raise the set point, or press the OPTIONS button to lower the set point.
A. Press LOCK and MEASURED FILL at the same time.
■Press and hold LOCK and MEASURED FILL for 3 seconds again to turn cooling back on.
20
