Connect the ³₈ " compression fitting to the water supply line prior to installing the unit into the cabinet opening. Attach such that the ³₄ " connection is facing upward as shown above.
Copper tubing only: Put the tubing into the 90° elbow fitting as far as it will go (the copper tubing bends and kinks easily). Slide the nut and ferrule forward and start the nut onto the elbow threads.
Flexible braided connection: Secure nut to elbow using ⁵₈ " open ended wrench or adjustable wrench.
NOTE: Do not use Teflon®† tape with compression fittings.
Move Dishwasher Close to Cabinet
Opening
WARNING
Excessive Weight Hazard
Use two or more people to move and install dishwasher.
Failure to do so can result in back or other injury.
NOTE: Do not install kick plate until instructed to do so
IMPORTANT:
NOTE: Do not push on the front of the panel or on the console. Panel or console may dent.
Helpful Tip: Temporarily tape utilities to the floor in the locations shown to prohibit them from moving when dishwasher is moved into the cabinet opening.
†®TEFLON is a registered trademark of E.I. Du Pont De Nemours and Company.
Check that water line is on the left side of opening and drain hose is near the center of the cabinet opening.
With another person holding the dishwasher to keep it from tipping, open and close the door a few times. If the door closes or falls open under its own weight, the door tension will need to be adjusted.
If the door closes too quickly, decrease the spring tension by moving the spring end toward the front of the dishwasher.
NOTE: Springs should be in the same notches on left and right sides.
16
