Whirlpool WFG710H0AH Cooktop cooking results not, What expected, Oven will not operate, Or noisy

PROBLEM	POSSIBLE CAUSES	SOLUTIONS
Cooktop cooking results not	Improper cookware	Ideal cookware should have a flat bottom, straight sides and a
what expected		well fitting lid, and the material should be of a medium to heavy
		thickness.
	Control knob set to incorrect	See “Cooktop Use” section.
	heat level
	Range is not level	Level the range. See the Installation Instructions.
Oven will not operate	Air in the gas lines	If this is the first time the oven has been used, turn on any one
		of the surface burner knobs to release air from the gas lines.
	Electronic oven control set	See “Electronic Oven Controls” section.
	incorrectly
	Control is locked.	Press and hold CONTROL LOCK for 3 seconds.
	The range is in Demo Mode.	Demo Mode will deactivate all heating elements. See “Demo
		Mode” in the “Electronic Oven Controls” section.
Convention fan not turning on.	The convection cycle is in the	This is normal. The convection fan will start running
	first 5 minutes of operation.	approximately 5 minutes into the cycle.
	Oven door is open.	If the oven door is opened during convention cooking, the fan
		will turn off immediately. It will come back on when the oven
		door is closed.
Oven burner flames are yellow	Range converted improperly	If propane gas is being used, contact a service technician or
or noisy		see cover for contact information.
Oven temperature too high or	Oven temperature is calibrated	See “Oven Temperature Control” in the “Electronic Oven
too low	incorrectly.	Controls” section.
Display shows messages	Power failure (display shows	Clear the display. On some models, reset the clock, if needed.
	flashing time)	See “Clock” keypad feature in the “Feature Guide” section.
	Error code (display shows letter	Press CANCEL to clear the display. See “Control Display” in
	followed by number)	the “Electronic Oven Controls” section. If it reappears, call for
		service. See cover for contact information.

Start needs to be pressed so a cycle can begin (display shows “PRESS START”).

See the “Start” keypad feature in the “Feature Guide” section.

Mineral deposits are left on the oven bottom after the Clean cycle

Tap water was used in the Clean cycle.

Use distilled or filtered water in the Clean cycle.

To remove deposits, use a cloth soaked with vinegar. Then use a cloth dampened with water to thoroughly remove any vinegar residue.

Range is not level.	Mineral deposits will collect on dry areas of the oven bottom
	during the Clean cycle. Level the range. See the Installation
	Instructions.
	To remove deposits, use a cloth soaked with vinegar. Then use
	a cloth dampened with water to thoroughly remove any vinegar
	residue.

17