OPERATING INSTRUCTIONS AND FUNCTIONS
The air conditioner can now be plugged into a 120V/60Hz dedicated 15amp socket. You are advised not to use an extension cord, however, if this is unaviodable, the extension cord must be 14 gauge, grounded at both ends and not more than 30 feet long.
The compressor is an essential component of the appliance for producing cold air. This appliance is fitted with a thermal protection device which allows the compressor to be started only after a time delay of up to three minutes.
Soft Touch Control Functions
CONTROL PANEL FUNCTIONS
1.POWER BUTTON: Press to turn unit “ON” or “OFF”. (NOTE: The Compressor requires up to 3 minutes to start from either being switched on, or when changing from dehumidify to any air conditioning cycle chosen).
2.FUNCTION BUTTON: Press this button to select the air conditioning function or dehumidification function.
3.TIMER BUTTON: Programmable timer ON/OFF button.
1.While the unit is off, press the “TIMER” button to set the number of hours (from 1 to 12 hours), from the current time, that you would like the unit to turn on.
2.When the time elapses, the unit will turn on automatically.
3.If you press the “POWER” key before the time elapses, the set time will be canceled and the unit will turn on.
1.While the unit is on, press the “TIMER” button to set the number of hours (from 1 to 12 hours), from the current time, that you would like the unit to turn off.
2.When the time elapses, the unit will turn off automatically.
3.If you press the “POWER” key before the time elapses, the set time will be canceled and the unit will turn off.
4.A/C FAN SPEED: Press the speed button to select either LOW, MEDIUM, HIGH or AUTO A/C fan speed. When using the auto function, the unit will start at maximum speed. As the room temperature changes up or down, the fan speed will adjust accordingly. When the room temperature reaches the set temperature, the compressor will shut off, as indicated by the blinking air conditioner indicator light on the control panel, and the fan will continue to operate to circulate the air.
5.SLEEP CONTROL FUNCTION: This function is designed to: (a) gradually increase the thermostat temperature, and hence the room temperature, as you fall asleep, and (b) shut the unit off. To set the “Sleep Comfort” mode, first press the sleep button. Then set the number of hours, from the current time, that you would like the unit to remain on by pressing the timer button until the desired hours are indicated on the L.E.D. display. The temperature setting may be varied in the “Sleep Comfort” mode by pressing the “UP” or “DOWN” buttons. For each press, the temperature will be increased or decreased by 1ºF. During the course of this cycle, the microprocessor memory will gradually raise the preset temperature 2º - 3ºF over a two hour period, maintain that temperature for the balance of the time set, and then shut the unit off.
CONTINUED ON NEXT PAGE
8
