WindChaser Products PACR12 instruction manual 1Air Conditioning or Dehumidifier Selector Button

CONTROL PANEL FUNCTIONS CONTINUED REMOTE CONTROL FUNCTIONS

6.L.C.D. DISPLAY: Indicates the room temperature and the timer and temperature settings. The unit’s LED displays the room temperature as soon as the power is turned on and after the timer or temperature is set.

7.ALARM INDICATOR LIGHT: This light will illuminate and this unit will shut off when the condensate tank is full and the unit cannot drain. The light will remain on and the unit will remain off until the condensation is drained through Drain (B). Please refer to the TROUBLESHOOTING GUIDE in this manual for further information.

8.TEMPERATURE REGULATION BUTTONS (UP AND DOWN): These buttons raise and lower the thermostat temperature setting by 1º each time they are pressed, ranging from 61ºF - 90ºF.

9.A/C INDICATOR LIGHT: Illuminates when the compressor is on and stays solid while the compressor is running. When the room temperature reaches the set temperature, the compressor turns off and the light blinks indicating that the unit has cooled the room to the set temperature.

10.DEHUMIDIFIER INDICATOR LIGHT: Press the “FUNCTION” button to select the dehumidification mode. When the dehumidification mode is on, the temperature buttons and the fan speed buttons do not function and the fan will operate on low speed. The dehumidifier indicator light will illuminate and stay solid while the unit is dehumidifying. When the humidity in the room is 50% or lower, the compressor will not run, the unit will not dehumidify, and the dehumidifier light will blink. Remember, the exhaust hose does not need to be used in dehumidifier mode.

NOTE: This unit has a three-minute compressor delay protection circuit. Thus, the compressor may take up to three minutes to start from either being switched on or when changing between the dehumidification and air conditioning functions.

IF THERE IS A POWER INTERRUPTION WHILE THE

UNIT IS OPERATING, THE UNIT WILL NOT TURN BACK ON AUTOMATICALLY WHEN THE POWER IS RE- STORED. THE UNIT MUST BE TURNED BACK ON MANUALLY. THE UNIT IS DESIGNED WITH THIS SAFETY FEATURE TO PROTECT THE COMPRESSOR.

COOL(1)

DRY
A/C
AUTO	(2)
LO
MED
HI
SET
	(3)
SLEEP	(4)
TIMER	ON
OFF
HR	(5)

ON/OFF (6)

1)Air Conditioning or Dehumidifier Selector Button

2)A/C Fan Speed Selector Button

3)Thermostat Temperature Setting UP and DOWN Buttons

4)Sleep Function Button

5)Timer Setting Button

6)Power ON/OFF Button

9