MACHINE TROUBLESHOOTING
PROBLEM | CAUSE | SOLUTION |
Little or no solution flow to the | Solution tank empty | Fill solution tank |
floor |
| Turn on or increase flow |
| Solution flow turned off or | |
| set too low | setting |
| Solution strainer plugged | Clean solution strainer |
| Solution hoses obstructed | Clear obstruction from |
|
| hose |
| Solution solenoid valve | Clean or replace |
| obstructed or stuck | Clear obstruction from vent |
| Vent hole in solution tank | |
| lid obstructed | hole |
No power to machine | Battery disconnected | Check all battery cable |
|
| connections |
| Emergency | Reset |
| activated (If included) | Clean connections |
| Battery connections | |
| corroded | Replace contactor |
| Faulty main contactor | |
|
| Replace switch |
| Faulty key switch | |
|
|
|
Little or no propel | Low battery charge | Charge batteries |
| Wheels spin | Decrease brush pressure |
| Controller overheated | Allow cool down period |
|
| Adjust brush shroud if |
|
| needed |
| Loose connection | Check motor wires and |
|
| connection |
CUTTER 36V (SCE) 86037030 12/05/06 |
|
