![](/images/new-backgrounds/1063943/6394335x1.webp)
WOLF WA R M I N G D R AW E R
I N T E G R AT E D FRONT PANEL
INSTALL CLEATS AND PLATFORM
For an overlay or inset application, you will need to install a recessed platform and cleats of the following dimensions into the opening.
Top Cleat Dimensions
749 mm W x 13 mm H x 51 mm D
Side Cleat Dimensions
13 mm W x 232 mm H x 51 mm D
Platform Dimensions
749 mm W x 16 mm H x 603 mm D
Depth of platform may increase depending cabinet depth.
For an overlay application, the platform and cleats will need to be recessed 5 mm. For an inset application, they must be recessed 5 mm plus the thickness of the decorative drawer panel, allowing the decorative panel to be flush with the front of the cabinet. Be sure to rigidly mount the platform so that it can support a minimum of 91 kg. Refer to the illus- trations below.
IMPORTANT NOTE: In an overlay application, be sure to recess the cleats no more than
5 mm. Recessing deeper than this may cause the drawer to not close properly.
IMPORTANT NOTE: Be sure to finish the inside lip of the opening and the front face of the shelf and cleats. Some of these areas will be visible when the drawer is open.
IMPORTANT NOTE: Be aware of the location of the mounting holes on the warming drawer frame to make sure the screws used to attach the cleats do not interfere with the screw holes for mounting the warming drawer.
Recessed cleats and platform – overlay application
Recessed cleats and platform – inset application
18