Wolf ICBWWD30 installation instructions Install Anti TIP Blocking

Models: ICBWWD30

1 94
Download 94 pages 29.84 Kb
Page 19
Image 19

I N S TA L L AT I O N I N S T RU C T I O N S

I N T E G R AT E D FRONT PANEL

INSTALL ANTI - TIP BLOCKING

Install a 51 mm x 51 mm or 51 mm x 102 mm anti-tip block against the rear cabinet wall as shown in the installation illustration for your specific installation on pages 11–13.

INSTALL WARMING DRAWER

Turn power off to the electrical outlet. Slide the left corner of the warming drawer into the opening. If the electrical outlet is installed inside the opening, plug the power cord into the outlet. The excess cord should be coiled behind or beside the unit. If the outlet is located in an adjacent cabinet, thread the power cord through the hole in the cabinet wall. Push the unit back into the opening until the warming drawer collar meets up with the recessed cleats and platform. Make sure the power cord does not get trapped under the warming drawer.

Open the drawer to its full extension. Drill pilot holes in each side hole, one located toward the front on each side of the warming drawer. Install the wood screws provided with the warming drawer. Refer to the illustration below. Turn power back on to the electrical outlet.

Warming drawer installation

19

Page 19
Image 19
Wolf ICBWWD30 installation instructions Install Anti TIP Blocking