S I G N AT U R E P O L I S H
Signature Polish is available from Signature Limited Laboratory,
P. O. Box 13436, Dayton, Ohio
W O L F FRYER MODULE U S E & C A R E
CARE R E C O M M E N DAT I O N S
| C O M P O N E N T | C A R E R E C O M M E N DAT I O N | ||
|
|
|
|
|
| Fryer Module | CAUTION: Make sure the fryer module is off and all surfaces are cool before | ||
| Frame and Lid | cleaning any part of the unit. | ||
| Stainless steel | Exterior Cleaning: Use a soft, nonabrasive stainless steel cleaner like | ||
|
| |||
|
| Signature Polish (see side note) and apply with a soft | ||
|
| out the natural luster, lightly wipe the surface with a | ||
|
| microfiber cloth, followed with a dry microfiber cloth. All work should follow | ||
|
| the same grain direction as the finish. Best results are obtained by keeping | ||
|
| the cloth in continuous contact with the metal. | ||
|
| For best results, wipe up spills and spatters as they occur and immediately | ||
|
| after the module has cooled. If splatters are allowed to dry, they may perma- | ||
|
| nently damage or stain the finish. | ||
|
| CAUTION: Do not use abrasive cleaners (e.g., Comet or Soft Scrub); they will | ||
|
| permanently scratch the surface. | ||
|
|
|
| |
| Fryer Basin | After emptying the oil from the fryer basin, pour 4 quarts (3.8 L) water with | ||
| Stainless steel | dish soap into the empty basin. Scrub with a nylon brush. Rinse well and | ||
|
| drain. Dry thoroughly. | ||
|
| WARNING: If the fryer basin is not dried thoroughly, excess water may | ||
|
| spatter hot oil, causing burns. | ||
|
| WARNING: Pay particular attention to the drain outlet and manual valve | ||
|
| when emptying, as oil may be hot. Allow unit to cool. | ||
|
|
|
| |
| Fryer Baskets | Both the large and small fryer baskets can be cleaned by hand with warm | ||
| soapy water or placed in the dishwasher. | |||
| wire mesh |
|
|
|
|
|
|
| |
| Basket Hanger | The wire basket hanger can be cleaned by hand with warm soapy water or | ||
| placed in the dishwasher. | |||
| wire mesh |
|
|
|
|
|
|
| |
| Control Panel | Use warm soapy water with a soft cloth to remove fingerprints and residual | ||
| Ceran glass | food and water stains from the control panel. Apply cleaner to the cloth | ||
|
| before wiping panel. Do not use aggressive commercial cleaners, as they | ||
|
| may damage the assembly. | ||
|
|
|
|
|
14
