Optional Floor Leg Mounting
A kit (119 800 451) is available from wolfcraft® that allows the mounting of leg extensions and shelves to your router table as shown. Leg extensions are adjustable in height from 32" to 38". A second lower shelf can be created by cutting a board and fastening it to the short leg extension pieces. See Figure 29.
|
| G |
|
| IN |
|
| N |
| R | |
A |
| |
W |
|
|
06 | 45 | 03 |
51
03
5 4
LEG
EXTENSIONS
SHELF
| G |
| N |
| I |
| N |
| R |
| A |
| W |
OPTIONAL SECOND | Figure 29 |
BOARD CUT SHELF |
Mounting a Dremel™ Rotary Hobby Tool (Not Included)
Extend the capabilities of your Dremel™ Tool by mounting it to the router table as follows: (Dremel™ Tool and Dremel™ #330 Router Attachment Kit not included):
NOTE: To mount your Dremel™ Tool, the Dremel™ #330 Router Attachment Kit must be purchased separately.
1.Attach the Dremel™ Rotary Hobby Tool to the Tool Holder Assembly from the Dremel™ #330 Router Attachment Kit as stated in the Router Attachment Kit Owner's Manual. See Figure 30, below.
L
E
M
E
R
D
¨
ON | OFF |
Figure 30
2.Secure the hobby tool assembly to the router table using the Bracket Mounting Screws from the #330 Router Attachment Kit.
3.Loosen wing nuts on fence slides and move them closer to the smaller Dremel™ router bit for better
workpiece support. DO NOT let the fence slides touch the router bit.
22
