First course
Strike a level line around the house and install Restoration
Shapes Starter (see illustration 1a). An alternative method of
starting Half-Rounds is to use J-channel in place of starter
strip, to receive the bottom edge of the panel (see illustration
1b). To use this method, the rounded portion of the panel must
be removed below the locking leg to create a continuous
straight edge.
NOTE: When using a J-channel as a starter, leave 1/4"
between the siding panel and pocket.
Remove 2-5/8" from the left side of the upper panel course,
leaving a 90° left side edge.
Starting on the left side of the wall, hook the bottom edge of
the panel into the starter strip and slide the panel into the
cornerpost or receiving channel. Leave 1/4" space between
the panel and the inside wall of the cornerpost for expansion.
Fasten the panel to the wall by first nailing through the round
center hole of the nailing hem at the top of the panel. Then
fasten the rest of the panel by nailing through the centers of
the remaining nail slots a maximum of every 8" to 16" on
center. Provide 1/8" to 1/16" between the nail head and the
panel to allow freedom of movement during normal expansion
and contraction. Failure to provide this space between nail
head and panel will cause the panel to buckle. Do not put a
nail into the far right slot until overlapping panel is positioned
for installation.
Install next panel by using a dual motion of hooking into the
starter strip and sliding over the previous panel. This will
ensure a proper lap.
Position overlapping panel so that there is 1/8" to 1/4"
between the panels, depending on the panel temperature at
time of installation. The spacing may appear larger or smaller
than the spaces between the shingles on the panel. This is
normal and necessary in order to allow for expansion and
contraction.
Nail in center of far left slot of overlapping panel.
Continue to install remaining panels of first course as
described above.
85
Wolverine Fit and Finish Installation Guide
1/4"
2-5/8"
always secure first
using center pin hole
1/8"-1/4"
illustration illustration
1a 1b