LOADERMOUNT INSTALLATION
Tractor Preparation
■Only use 211822 Loader Mounting Kit for mounting Woods 1020/1027 loaders on Massey
Ferguson® 5425, 5435, 5445 or Challenger® MT425B, MT445B tractors. Any other use or modi- fication of this mounting kit may result in serious injury or death.
IMPORTANT
■This equipment must be assembled and installed on the customer’s tractor by the Woods dealer. Dealer must thoroughly inspect equipment and complete each item on the
■Clean threaded holes in the tractor chassis thoroughly, using a tap of the proper size. Paint, rust or debris in the threads may not permit cap screws to be installed and tightened correctly.
For installing this mounting kit, references to right, left, forward, and rearward directions are determined from the operator’s position in the tractor seat.
1.Shut off engine and set parking brake during installation.
2.Remove the tractor’s front fenders if so equipped. Front fenders can not be used with loader.
3.Remove the tractor front weights and front weight bracket, if equipped.
4.Set front tire width to approximately 64". See Figure 1.
NOTE: Maximum front tires size for use with the 1020 or 1027 loader is 14.9R24.
5.Remove tool box from under right side of cab, if equipped.
6.Loosen steel bands from around fuel tank on left side of tractor and slide tank out away from tractor.
7.Remove hardware and spacers from the bottom of cab support brackets. See Figure 2. Save bolts for later use.
NOTE: The temporary removal of these parts will allow access to mounting areas on the tractor.
64"
SC86VAR
Figure 1. Tire Adjustment (FWA Models)
Cab Support
Bracket
Spacer
DP1a
Figure 2. Right Cab Support Bracket, Bottom View
4 Mount Installation | MAN0469 (9/9/2005) |
|
|